Flue pipe 90° bend kit
kr500.00
This flue pipe allows installation for rear or side smoke outlets. Compatible with the Spirit³ and Grace³ stoves.
The TILE 3 PLUS pellet stove has been designed primarily to offer a space-saving installation. With a depth of only 26,5 cm, this "flat" stove also offers 3 smoke outlets to be easily adapted to where you want to install it.
It can also conduct hot air up to 6m via a separate air duct, and you can thus more efficiently heat and maintain the desired temperature in the other rooms in the same way as in the room where the stove is located.
Cadel's Plus range offers duct stoves that can blow hot air into different rooms. With its "flat" format, its discreet elegance, TILE 3 PLUS can be installed anywhere in the house. It can therefore find its place in a corridor, a stairwell, an entrance, a hall, or of course in the living room.
Up to 94.5% efficiency, to get most of the energy from the pellets.
The stove can be installed with a so-called horizontal flue instead of a traditional chimney. With our popular chimney solution, the stove is easily installed against an external wall through a hole in the wall.
With this ingenious solution, the combustion air is extracted from outside in the same flue as the flue gases exit. This cools the flue gases, while preheating the combustion air and increasing the efficiency of your stove.
The chimney is completely passive, which means that the stove's flue gas fan ensures that the flue gases come out. And you can easily access the flue pipe by lifting the protective cover from the outside, which makes it very easy to maintain.
Sealed chamber
Cast iron burning pot
Comfort mode
Integrated Wi-Fi
Remote control (optional)
Connection to external thermostat
Daily and weekly programming
Smoke connection backwards, upwards or from the side
Cast iron door
Concentric flue (optional)
Can be installed without a chimney
Duction with 1 independent motor
Data sheet
(*) The specified values for heatable volume and surface represent the number of cubic meters and square meters, respectively, that the product can heat, based on the average heating demand for a typical house (expressed in W/m³ and W/m²). The values provided are for guidance only, and a professional assessment is required for mandatory energy calculations.